350-601 Questions PDF [2023] Use Valid New dump to Clear Exam [Q63-Q81]

Share

350-601 Questions PDF [2023] Use Valid New dump to Clear Exam

Passing Cisco 350-601 Exam Using 2023 Practice Tests

NEW QUESTION 63
A Cisco Nexus 7000 Series switch runs VXLAN, and interface Ethernet 7/30 is configured as a trunk port. Which command set configures the switch to act as a gateway for VLAN 50?
interface Ethernet7/30
no switchport
no shutdown
service instance 1 vni
no shutdown

  • A. encapsulation profile vni VSI_50_TO_500
    dot1q 50 vni 500
    bridge-domain 50
    member vni 500
    interface Vlan50
    ip address 10.50.50.51/24
  • B. encapsulation profile vni VSI_50_TO_500
    dot1q 500 vni 50
    bridge-domain 500
    member vni 50
    interface Bdi500
    ip address 10.50.50.51/24
  • C. encapsulation profile VSI_50_TO_500 default
    encapsulation profile vni VSI_50_TO_500
    dot1q 500 vni 50
    bridge-domain 500
    member vni 50
    interface Vlan500
    ip address 10.50.50.51/24
  • D. encapsulation profile vni VSI_50_TO_500
    dot1q 50 vni 500bridge-domain 50
    member vni 500
    interface Bdi50
    ip address 10.50.50.51/24

Answer: D

 

NEW QUESTION 64
Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency?
A)

B)

C)

D)

  • A. Option A
  • B. Option D
  • C. Option B
  • D. Option C

Answer: C

 

NEW QUESTION 65
An engineer is implementing Cisco Intersight in a secure environment. The environment must use LDAP directory service and ensure information integrity and confidentiality. Which two steps must be taken to implement the solution? (Choose two.)

  • A. Enable Encryption for LDAP
  • B. Add a trusted root LDAP certificate to Cisco Intersight
  • C. Add a trusted OAuth token to Cisco Intersight
  • D. Add a self-signed LDAP certificate to Cisco Intersight.
  • E. Enable Certificate Signing Request in Cisco Intersight.

Answer: A,B

Explanation:

https://www.cisco.com/c/en/us/td/docs/unified_computing/Intersight/
b_Cisco_Intersight_Appliance_Getting_Started_Guide/
b_Cisco_Intersight_Appliance_Install_and_Upgrade_Guide_chapter_0110.html

 

NEW QUESTION 66
What is the impact of an EPLD upgrade on a Cisco MDS 9000 Series Switch?

  • A. The upgrade process disrupts only the module that is being upgraded.
  • B. The active supervisor traffic is disrupted.
  • C. The standby supervisor module reloads multiple times.
  • D. The upgrade disrupts the management connectivity to the switch.

Answer: A

 

NEW QUESTION 67
In an FCoE environment, for which two sets of data must an interface that implements the PAUSE mechanism always provision sufficient ingress buffer? (Choose two)

  • A. frames that were sent with high credit
  • B. frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender
  • C. frames that were processed and transmitted by the transmitter after the PAUSE frame left the sender.
  • D. frames that were sent on the link and received.
  • E. frames that were sent on the link but not yet received.

Answer: B,E

Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/fcoe/config/ cisco_nexus7000_fcoe_config_guide_8x/configuring_fcoe.html

 

NEW QUESTION 68
An engineer must recover configuration on a Cisco MDS 9000 Series switch from a previous version that was backed up to bootflash and then verify the restoration.
Drag and drop the commands on the left to the correct order on the right.

Answer:

Explanation:

Explanation

 

NEW QUESTION 69
A DNS server with IP address 192.168.1.1 is deployed in a data center A network engineer must configure a Cisco UCS Fabric Interconnect to use this DNS. Which configuration should be applied?

  • A. Option A
  • B. Option D
  • C. Option B
  • D. Option C

Answer: B

 

NEW QUESTION 70
An engineer must allow communication between the APIC controller and an OpenStack OpFlex agent. The agent is running on a compute node directly plugged to a Cisco ACI leaf switch. The engineer must enable and extend Infra VLAN on the port facing the compute and extend the Infra VLAN to the host. Which action must be taken to meet these requirements?

  • A. Add the infra VLAN via the VMM domain.
  • B. Enable the Infra VLAN on the Interface Profile policy
  • C. Enable the Infra VLAN on the Attachable Access Entity Profile.
  • D. Add the infra VLAN via the physical domain.

Answer: D

 

NEW QUESTION 71
An engineer must implement a Cisco UCS system at a customer site. One of the requirements is to implement SAN boot. The storage system maps the source WWPN to a unique LUN. Which method does Cisco recommend to configure the SAN boot?

  • A. Define the vHBAs as bootable and leave the default values on the target definition.
  • B. Define the vHBAs as bootable and leave the boot target definition empty.
  • C. Create a SAN boot policy in which every initiator is mapped to a different target LUN.
  • D. Create a SAN boot policy in which every initiator is mapped to the same target LUN.

Answer: D

Explanation:
While you have multiple zones consisting of FC vHBAs and storage target wwpns for SAN Fabrics A and B, you are ultimately booting off of the same boot LUN. Multiple paths to get to the same boot device which correspond with the same LUN ID.
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ts/guide/UCSTroubleshooting/ UCSTroubleshooting_chapter_0110.html#r_sanarrayconfigurationchecklist

 

NEW QUESTION 72
A storage engineer must configure zoning on a Cisco MDS 9000 Series switch. Drag and drop actions from the left into the order on right

Answer:

Explanation:

 

NEW QUESTION 73


Refer to the exhibits An engineer must implement a SPAN session that sends a copy of all VLAN 11 traffic on N5K_1 to the Traffic Capturing Device The configuration that is presented is already applied to the Cisco UCS Manager. Which additional action meets the objective'?

  • A. Select the Clear Destination feature.
  • B. Choose VLAN 11 under the VSANs section.
  • C. Create a LAN traffic monitoring session.
  • D. Assign the VLAN to the monitored port.

Answer: B

 

NEW QUESTION 74
Refer to the exhibit.

What be connected to clear the HA NOT READY status?

  • A. server chassis
  • B. network uplinks
  • C. management ports
  • D. Layer 1-Layer 2 ports

Answer: A

 

NEW QUESTION 75
Refer to the exhibit.

All switches are configured with the default OSPF priority. Which configuration should be applied to ensure that the SW2 Cisco Nexus switch controls the LSA floods and advertises the network to the remaining nodes in the OSPFv2 area?

  • A. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 1
  • B. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 255
  • C. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 0
  • D. SW2# configure terminal SW2 (config)# router ospf 1 SW2 (config-router)# router-id 10.10.10.22

Answer: B

Explanation:
Explanation
Priority in OSPF is mainly used to influence/determine a designated router/backup designated router for a network. By default, the priority is 1 on all routers. A router with a high priority will always win the DR/BDR election process.

 

NEW QUESTION 76
Refer to the exhibit.

Which command is run from the Guest Shell to set the description on the first five interfaces of the Cisco Nexus switch?

  • A. Option A
  • B. Option D
  • C. Option B
  • D. Option C

Answer: B

Explanation:
NXs1# guestshell
[admin@guestshell ~]$ for x in {1..5}; do dohost "conf t ; interface eth1/$x ; description Server$x" ; done Enter configuration commands, one per line. End with CNTL/Z.
Enter configuration commands, one per line. End with CNTL/Z.
Enter configuration commands, one per line. End with CNTL/Z.
Enter configuration commands, one per line. End with CNTL/Z.
Enter configuration commands, one per line. End with CNTL/Z.
[admin@guestshell ~]$

 

NEW QUESTION 77
Refer to the exhibit.

What is the reason the system-fm-vrrp checkpoint was created?

  • A. The network administrator manually created it.
  • B. The VRRP-enable feature has been disabled.
  • C. The VRRP process crashed and the checkpoint was automatically created.
  • D. The VRRP service restarted and the checkpoint was automatically created.

Answer: B

Explanation:
Explanation
automatically created by the Nexus when the vrrp feature is disabled

 

NEW QUESTION 78
A network engineer must determine the cooling requirements for a Cisco UCS C-Series Rack Server. The server with PCIe cards is configured with a fan configuration policy. Which configuration should be used for the fan policy of the server?

  • A. Option D
  • B. Option A
  • C. Option B
  • D. Option C

Answer: B

 

NEW QUESTION 79
Which statement about the MAC address that the FCoE Initialization Protocol chooses for use by an E-Node in an FCoE implementation is true?

  • A. The FCoE Initialization Protocol uses 01.00.0C as the first 24 bits of the MAC address and appends a 24-bit Fibre Channel ID to derive a full 48-bit FCoE MAC address.
  • B. The FCoE Initialization Protocol uses the burned-in MAC address of the converged network adapter for all FCoE operations.
  • C. FCoE does not use a MAC address. The FCoE Initialization Protocol is used to acquire a Fibre Channel ID, and the address is used for all FCoE communications in the same way as Fibre Channel Protocol.
  • D. The FCoE Initialization protocol uses a 24-bit FC-MAP and concatenates a 24-bit Fibre Channel ID to create a fibric-provided MAC address.

Answer: D

Explanation:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/UF_FCoE_final.html#wp1154912

 

NEW QUESTION 80
What is an advantage of NFS as compared to Fibre Channel?

  • A. NFS provides the dynamic allocation of storage capacity.
  • B. NFS removes the impact of IP overhead.
  • C. NFS enable thin provisioning for LUNs.
  • D. NFS provides direct access to the underlying storage hardware.

Answer: A

Explanation:
https://www.ciscolive.com/c/dam/r/ciscolive/apjc/docs/2018/pdf/BRKINI-1011.pdf

 

NEW QUESTION 81
......


Test Content Outline

The Cisco 350-601 exam covers 5 key knowledge areas that are usually addressed by the CCNP Data Center certificate. These include the following:

  • Network (25%);
  • Security (15%).
  • Automation (15%);
  • Storage Network (20%);
  • Compute (25%);

 

350-601 Study Guide Brilliant 350-601 Exam Dumps PDF: https://www.practicevce.com/Cisco/350-601-practice-exam-dumps.html

View 350-601 Exam Question Dumps With Latest Demo: https://drive.google.com/open?id=1ZMKfAzvb9Gbacc9YZjPDl-W43khaqvqO