New 2021 Guaranteed Success with PracticeVCE 350-501 Dumps Cisco PDF Questions
Exceptional Practice To Implementing and Operating Cisco Service Provider Network Core Technologies Pass the First Time
NEW QUESTION 73
Refer to the exhibit:
Based on the show/ command output, which result m true after BGP session is established?
- A. The IOS XR router advertises and accepts all routes to and from eBGP neighbor 192.168.2.2
- B. No routes are accepted from the neighbor 192.168.2.2, nor are any routes advertised to it
- C. The IOS XR router does not advertise any routes to the neighbor 192.168.2.2,but it accepts all routes from 192.168.2.2.
- D. The IOS XR router advertises all routes to the neighbor 192.168.2.2, but it does not accept any routes from 192.168.2.2
Answer: B
NEW QUESTION 74
Refer to the exhibit.
An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?
- A. PE-A(config-if)#no ip pim bsr-border
- B. PE-A(config-if)#ip pim sparse-dense-mode
- C. PE-A(config-if)#ip igmp version 3
- D. PE-A(config-if)#ip pim sparse-mode
Answer: B
NEW QUESTION 75
A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements:
A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements
* Management protocols must be marked with DSCP AF class 2 w4h low drop probability.
* Monitoring protocols must be marked with DSCP AF class 1 with low drop probability.
* All remaining traffic must be marked with a DSCP value of 0.
Which configuration must the engineer implement to satisfy the requirements?
A)
B)
C)
D)
- A. Option D
- B. Option C
- C. Option A
- D. Option B
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/guide/nexus1000v_qos/qos_6dscp_val.pdf
NEW QUESTION 76
Refer to the exhibit.
A network engineer Is implementing OSPF multiare
a. Which command on interface G0/1 resolves adjacency Issues in the new area?
- A. Ip ospf network polnt-to-multlpoint
- B. Ip ospf network point-to-point
- C. Ip ospf network non-broadcast
- D. Ip ospf network broadcast
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_ospf/configuration/xe-16/iro-xe-16-book/iro-multi-area-adj-xe.html
NEW QUESTION 77
What are two characteristics of MPLS TE tunnels? (Choose two.)
- A. They require EIGRP to be running in the core
- B. They are run over Ethernet cores only
- C. They use RSVP to provide bandwidth for the tunnel
- D. The headend and tailend routers of the tunnel must have a BGP relationship
- E. They are unidirectional
Answer: C,E
Explanation:
Section: MPLS and Segment Routing
Explanation/Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_te_path_setup/configuration/xe-3s/mp-te-path-setup-xe-
3s-book/mp-te-auto-bandwdth.html
https://www.ciscopress.com/articles/article.asp?p=426640&seqNum=2
NEW QUESTION 78
Drag and drop the multicast concepts from the left onto the correct descriptions on the right.
Answer:
Explanation:
Explanation
1: PIM-DM 2:IGMP 3:PIM-SM 3:shared tree 4:source tree
NEW QUESTION 79
Refer to the exhibit:
A network engineer is implementing a BGP protocol. Which effect of the locat-as keyword in this configuration is true?
- A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family
- B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family
- C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.
- D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration
Answer: C
NEW QUESTION 80
Refer to the exhibit. Which additional configuration must an engineer to the adge router to inject a default router into the MP-BGP address family for the internet_Shared_Services dedicated VRF?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 81
An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?
- A. An offset list to set the metric for routes received from neighboring autonomous systems
- B. An access list to identify traffic and enable it on both of the provider-facing interfaces
- C. A route map with WEIGHT attribute to control the inbound traffic
- D. A route map with AS-PATH attribute to control the inbound traffic
Answer: D
Explanation:
Section: Networking
NEW QUESTION 82
Which utility can you use to locate MPLS faults?
- A. MPLS LSP ping
- B. QoS
- C. MPLS traceroute
- D. EEM
Answer: C
NEW QUESTION 83
A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider can connect to these two locations.
Which statement about this scenario is true?
- A. When edge routers at different regional sites are connected over the global carrier backbone, MP-eBGP must run between the routers to exchange the customer VPNv4 routes.
- B. When IGP is used for route exchange and LDP for label exchange, MPLS is enabled only on the VRF interface on the backbone-carrier PE side.
- C. When BGP is used for both route and label exchange, the neighbor a.b.c.d send-label command is used under the address-family VPNv4 command mode.
- D. When eBGP is used for label exchange using the send-label option, MPLS-BGP forwarding is configured under the global ABC CSC PE-to-CE interface.
Answer: D
Explanation:
Section: Services
NEW QUESTION 84
Drag and drop the OSs from the left onto the correct deceptions on the right.
Answer:
Explanation:
NEW QUESTION 85
Drag and drop the technologies from the left onto the correct definitions on the right.
Answer:
Explanation:
NEW QUESTION 86
Refer to the exhibit:
With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
- A. 192.168.0.5
- B. 192.168.0.3
- C. 192.168.0.1
- D. 192.168.0.4
Answer: B
NEW QUESTION 87
Drag and drop the functionalities from the left onto the correct target fields on the right.
Answer:
Explanation:
NEW QUESTION 88
Refer to the exhibit.
An engineer began to configure LDP between R1 and R2, but R1 and R2 cannot yet establish an LDP TCP connection. Which additional task must be completed to finish the implementation?
- A. Configure the mpls Idp neighbor 10.0.12.1 password command on R1
- B. Configure the mpls Idp neighbor 172.16.0.1 password command on R1
- C. Configure the no mpls Idp password option 1 command on R1
- D. Configure the no mpls Idp password option 1 command on R2
Answer: B
NEW QUESTION 89
......
350-501 EXAM DUMPS WITH GUARANTEED SUCCESS: https://www.practicevce.com/Cisco/350-501-practice-exam-dumps.html
Best Quality Cisco 350-501 Exam Questions: https://drive.google.com/open?id=1PIkrxbq-Sxcr2dULVdj8sSFzFqk_8iwH