Pass Cisco 350-501 PDF Dumps | Recently Updated 451 Questions
Updated Test Engine to Practice 350-501 Dumps & Practice Exam
Services: 20%
- Configuring L3 Virtual Private Network (Shared services and Intra-AS VPN);
- Implementing multicast services, including PIM, IGMP, and MLD;
- Configuring L2 Virtual Private Network and Carrier Ethernet (Ethernet services, Ethernet OAM, and VLAN tag manipulation);
- Implementing QoS services (classification, marking, shaping, traffic policing, and congestion avoidance).
- Describing the Virtual Private Network services, such as mVPN, Inter-AS VPN, CSC, and EVPN;
Cisco 350-501 certification exam is a valuable credential for IT professionals who want to advance their careers in the service provider industry. Implementing and Operating Cisco Service Provider Network Core Technologies certification can help candidates stand out to potential employers, demonstrate their expertise in complex networking technologies, and open up new job opportunities.
NEW QUESTION # 217
Refer to the exhibit.
A network operator working for a telecommunication company with an employee ID: 4350:47:853 must implement an IGP solution based on these requirements:
* Subnet 10.50.10.0 traffic must exit through the R1 router to connect with the Syslog server.
* Subnet 10.50.20.0 traffic must exit through the R2 router to connect with the NTP server.
* In case of link failure between R2 and R4, traffic must be routed via R1 and R3.
Which two configurations must be implemented on R5 to meet these requirements? (Choose two.)
- A. Apply a route policy to redistribute 10.50.20.0 from ISIS-L2 to OSPF Area 0 at a higher cost.
- B. Enable a route policy to advertise 10.50.10.0 In OSPF Area 0 at a low cost.
- C. Apply a route policy to redistribute 10.50.0.0 prefixes in OSPF to ISIS and ISIS to OSPF.
- D. Apply a route policy to redistribute 10.50.10.0 from OSPF Area 0 to ISIS-L2 at a lower cost.
- E. Enable a route policy to advertise 10.50.20.0 in ISIS-L2 at a higher cost.
Answer: B,E
NEW QUESTION # 218
A network operator needs to implement PIM-SSM multicast configuration on customer's network so that users in different domains are able to access and stream live traffic. Which two actions must the engineer perform on the network to make the streaming work? (Choose two.)
- A. Enable IGMP version 3 at the interlace level.
- B. Configure at least one MSDP peer on the network.
- C. Enable IGMP version 2 at the interface level.
- D. Enable PIM dense mode on the device.
- E. Enable PIH sparse mode on the device.
Answer: A,B
NEW QUESTION # 219
Which control plane protocol is used between Cisco SD-WAN routers and vSmart controllers?
- A. OTCP
- B. UDP
- C. OMP
- D. BGP
Answer: C
NEW QUESTION # 220
Drag and drop the functions from the left onto the Path Computation Element Protocol roles on the right.
Answer:
Explanation:
Explanation
PCE - 1,2,5
PCC- 3,4
NEW QUESTION # 221
Refer to the exhibit. Which configuration prevents the OSPF neighbor from establishing?
- A. default-metric
- B. network statement
- C. duplex
- D. mtu
Answer: D
NEW QUESTION # 222
Refer to the exhibit.
An engineer configured BGP summarization on a customer's network. Which route is advertised to BGP peers?
- A. 192.168.1.0/24
- B. 192168.0.0/16
- C. 192168.0.5/30
- D. 192.0.0.0/16
Answer: B
NEW QUESTION # 223
Refer to the exhibit:
What is the URL used for with REST API?
- A. It is used to contact a URL filter to determine the efficacy of a web address
- B. It is used to send a TACACS+ authentication request to a server
- C. It is used to send a message to the APIC to perform an operation on a managed object or class operator
- D. It is used to initiate an FTP session to save a running configuration of a device.
Answer: C
NEW QUESTION # 224
Which two IS-IS parameters must match before two Level 2 peers can form an adjacency?
(Choose two )
- A. MTU
- B. hello timer setting
- C. authentication settings
- D. system ID
- E. area ID
Answer: A,C
NEW QUESTION # 225
Drag and drop the characteristics from the left onto the automation tool on the right.
Answer:
Explanation:
NEW QUESTION # 226
Refer to the exhibit.
Which show command should be implemented to display per-interface statistics about uRPF drops and suppressed drops?
- A. show ip interface brief
- B. show cef interface
- C. show ip traffic
- D. showip interface
Answer: D
NEW QUESTION # 227
Refer to the exhibit:
Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?
- A. The neighbor relationship is up
- B. The neighbor relationship is down because R1 believes R2 is in AS 65012.
- C. The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement
- D. The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family
Answer: B
NEW QUESTION # 228
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right
Answer:
Explanation:
Explanation
Path Computation Element (Calculates paths through the network, keeps TE topology database information, sends path status updates) Path computation Client (sends path calculation request, sends path creation request) Path Computation Element (PCE) Represents a software module (which can be a component or application) that enables the router to compute paths applying a set of constraints between any pair of nodes within the router's TE topology database. PCEs are discovered through IGP.
Path Computation Client (PCC)
Represents a software module running on a router that is capable of sending and receiving path computation requests and responses to and from PCEs. The PCC is typically an LSR (Label Switching Router).
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r5-3/mpls/configuration/guide/b-mpls-cg53x-crs
NEW QUESTION # 229
Refer to the exhibit. While troubleshooting a connectivity issue on router R2, a network engineer with an employee id:3876.13.497 notices that although it detects three OSPF links from R1, the OSPF prefixes are missing from the routing table. What is the reason for the problem?
- A. The serial interfaces have different MTUs
- B. The R2 Serial 1/0 interface is configured with an IP address, but the R1 Serial R1 Serial 1/0 interface in unnumbered.
- C. The subnet masks on the serial interfaces are mismatched.
- D. Both loopback interfaces on R1 are configured as stub
Answer: B
NEW QUESTION # 230
Refer to the exhibit:
Which statement describes the effect of this configuration?
- A. It matches HTTP traffic for use in a policy map
- B. It modifies the default policy map to allow all HTTP traffic through the router
- C. It creates an ACL named WEB that filters HTTP traffic.
- D. It applies a service policy to all interfaces remarking HTTP traffic
Answer: A
NEW QUESTION # 231
Drag and drop the functionalities from the left onto the target fields on the right.
Answer:
Explanation:
NEW QUESTION # 232
Drag and Drop Question
Drag and drop the descriptions from the left onto the corresponding OS types on the right.
Answer:
Explanation:
NEW QUESTION # 233
Refer to Exhibit. A network engineer is trying to retrieve SNMP MIBs with RESTCONF on the Cisco switch but fails. End-to-end routing is in place. Which configuration must the engineer implement on the switch to complete?
- A. netconf-yang cisco-ia snamp-community-string Public
- B. netconf-yang cisco-Ia snmp-community-string Private
- C. snmp-server community public RO
- D. snmp-server community cosco RW
Answer: B
Explanation:
https://www.cisco.com/c/en/us/support/docs/storage-networking/management/200933-YANG- NETCONF-Configuration-Validation.html
NEW QUESTION # 234
How much must the MTU be increased when configuring the 802.1q VLAN tag?
- A. 12 bytes
- B. 2 bytes
- C. 8 bytes
- D. 4 bytes
Answer: D
NEW QUESTION # 235
Refer to the exhibit.
Refer to the exhibit. A network engineer with an employee ID 4379:43:595 is setting up an IS-IS network with these requirements:
* Routes with a tag of 80 and IP prefixes other than 192.168.10.20/24 must be redistributed from Level 1 into Level 2.
* Route leaking must be configured from Level 2 into the Level 1 domain for routes that are tagged with only 50 or 40.
Which configuration must be implemented on RB to meet the requirements?
- A. DUMPS Add match ip address 152 in route-map redist1-2
- B. Add match tag 80 in route-map Ieak2-1
- C. Change match tag 80 to match tag 50 in route-map redist1-2.
- D. Remove match tag 40 from route-map Ieak2-1
Answer: C
NEW QUESTION # 236
Refer to the exhibit.
A network operator must configure CSR1 interlaces GigabitEihernet2 and GigabitEthemet to rewrite VLAN tags 12 and 21 for traffic between R1 and R2 respectively. Which configurator accomplishes this task?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 237
Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
- A. 192.168.0.1
- B. 192.168.0.3
- C. 192.168.0.4
- D. 192.168.0.5
Answer: D
NEW QUESTION # 238
Which configuration mode do you use to apply the mpls Idp graceful-restart command in IOS XE Software?
- A. interface
- B. LDP neighbor
- C. global
- D. MPLS
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_ha/configuration/xe-3s/mp-ha-xe-3s- book/mp-ldp-grace-rstrt.html
NEW QUESTION # 239
An engineer working for telecommunication company with an employee id: 3715 15 021 needs to secure the LAN network using a prefix list.
Which best practice should the engineer follow when he implements a prefix list?
- A. An engineer must include only the prefixes for which he needs to log activity.
- B. The final entry in a prefix list must be /32
- C. An engineer must use non sequential sequence numbers in the prefix list so that he can insert additional entries later.
- D. An engineer must identity the prefix list with a number only
Answer: C
NEW QUESTION # 240
......
Cisco 350-501 Dumps Cover Real Exam Questions: https://www.practicevce.com/Cisco/350-501-practice-exam-dumps.html
Dumps Collection 350-501 Test Engine Dumps Training With 451 Questions: https://drive.google.com/open?id=1wDmWx5hEftsBFU05ksPe0wSdPGbrAyJs